---

Spray the backside of the front dieline printout with temporary adhesive and smooth it on top of the fabric.

---

Cut out the shape and repeat to make the back dieline piece. After cutting, make sure to fold up one corner of the paper dieline to make it easier to remove later.

---

Freestanding organza designs have been specially digitized for water-soluble stabilizer. After the stabilizer is removed, beautiful lace remains behind.

---

There are a couple of different kinds of water-soluble stabilizer. One is clear and plastic, and that brand is Sulky Ultra Solvy. The other is soft and fibrous, called Vilene. Both will work very well. Vilene is used in this demonstration. Use a size 11 or 75/11 sharp sewing needle. A sharp sewing needle has a smaller, finer point than an embroidery needle. That means it will make smaller holes in the stabilizer.

---

Freestanding organza is seen from both sides, so wind a bobbin with the same thread that you're using in the needle.

---

Hoop the stabilizer firmly. Make sure it is nice and tight with no wrinkles.

---

Load the embroidery file onto the machine (not the dieline), and embroider the design. The first thing to embroider will be a dieline, or outline stitch. This marks the area on the stabilizer where we'll place the front fabric piece.

---

Spray the back of the front piece with temporary adhesive. Remove the hoop from the machine, but do not unhoop the stabilizer. Place the fabric piece right inside the sewn dieline (after removing the paper). Some designs, like our Magical Autumn Votive Wrap, have only one tackdown step, so you can add the back piece of organza at the same time you add the front piece.

---

Reattach the hoop to the machine and continue with the design. A tack down will sew next. This binds the front fabric piece in place for the remainder of the design.

---

>	Look at the color change sheet, and stop the machine before sewing "back piece tack down". Remove the hoop from the machine, but do not unhoop the stabilizer. Spray the backside of the back dieline with temporary adhesive, and place it on the back of the embroidery.

---

Place the hoop back on the machine, and embroider the back piece tack down. Next, all of the inner elements will sew followed by the final outer border along the edge of the organza pieces.

---

After embroidering, cut the excess stabilizer away.

---

The stabilizer's packaging should give instructions for removing the excess. For Vilene, soak the organza pieces for a few moments. Air dry, then press using a pressing cloth.

---

Machine or hand stitch (using a hand sewing needle) the freestanding organza pieces to shirt fronts or jackets for a playful and fun look.

---

Even add them to a pillow for a fun layered effect.

---

Create a jungle wreath by combining the organza leaf with a lace hibiscus from our sister brand Urban Threads. Add an assortment of leaves in different sizes and colors to a metal ring to make a modern summer wreath. Fresh and lovely!

---

To make the organza accent into an ornament, cut a piece of ribbon that it 7" long. Make it into a loop, and glue it onto the back of the organza accent.

---

To make a freestanding organza candle wrap, cut your organza with the provided dielines and follow the same steps above. Then, use glue or needle and thread to bring the two ends of the candle wrap together.

---

This project is featured on the Embroidery Library Pinterest page. Pin it yourself using the "Pin It" button on this page.

---

Questions or comments? Let us know! Send an email to us; the address is stitch@emblibrary.com.